BASIC INSTRUCTIONS
Mount position
When installing the mount inside the helmet, place it at the same height as the temples of regular glasses or slightly higher.
If the mount is positioned too low, the glasses may tilt upward and may not fit properly.
The mount can be installed with the tab facing upward or downward, depending on the helmet and fit.
Strap tension
Temple Free is worn with a strap, but it is designed to function as eyewear, not goggles.
Please do not tighten the strap so much that it presses hard against your face like goggles.
If the strap is pulled too tight, the glasses may tilt upward and may not fit properly.
Like the temples of regular glasses, the strap is designed to support the eyewear, so after tightening it, we recommend loosening it slightly for a more comfortable fit.
Attaching the eyewear
Temple Free is worn by snapping the strap block on the frame into the helmet mount.
There are two ways to fasten the snap.
1) Fastening the snap after putting on the helmet
This method becomes convenient once you are familiar with the product,
but first time users may find it slightly difficult to locate the snap position accurately.
2) Putting on the eyewear first, then wearing the helmet
Step 1: attach the eyewear to the helmet.
Step 2: put on the helmet with the strap loosened.
Step 3: Then tighten the strap to secure the fit.
This method is especially recommended until you become familiar with the snap position.
When taking it off, loosen the strap first and remove it together with the helmet.
Step 1
Step 2
Step 3
Managing excess strap length with the adjust ring
The required strap length will vary depending on the helmet and the rider.
If the strap is left too long, it can look untidy and may also interfere with the helmet shield.
Temple Free includes an adjust ring designed to keep excess strap length in place.
Using this ring allows you to secure the remaining strap neatly.
Before adjustment
After adjustment
Installing and removing the wind guard
Temple Free TF4001 comes with a removable wind guard.
The wind guard can be attached and removed easily without tools and with only light pressure.
Insert it into the upper and lower openings of the frame,
then press until it clicks securely into place on the pipe section.
The wind guard is recommended for use with open face helmets.
If you are using a full face helmet
or riding with the helmet shield down,
please remove the wind guard before use.
If you feel any pressure or discomfort around the cheekbones or cheeks,
please remove the wind guard before use.
